|Motor Size:||29 millimeters|
|Recommended Motors:||2xG40-10, 2xG80-13, 4xF23-7, 4xF25-9, 4xF50-9|
It is a nice mid-high power rocket that makes you enjoy clustering The packaging was standard Loc plastic bag but it made it through the mail ok. The fins were hard to align because they just stuck in between the motor tubes. I did ok by using a square. Everything else went ok. The instructions were vague to me but that's ok I had a lot of fun figuring it out (no note of sarcasm). It was easy ...
Single staged, but with the choice of being flown with two or four 29mm motors, specified as 2 G type or 4 F type. It has the fins attached wedge style between the four motor tubes, which extend below the main body tube. The nose cone is hollow plastic, and the fins are precut plywood. The tubes are spiral wound kraft paper. The parachute is a lightweight pink nylon. Very bright ...
I wanted to make it taller with a huge payload section. Modifications: Well I built it following the instructions carefully. Then I sliced the BT in half. The lower section stayed on the booster but the upper was shot so I replace it with a packing tube. This is where I got the extra height. I couldn't order a bulkhead coupler assembly so I just sliced the one off the nose cone (leave at ...