bannerbanner
Albums >>

Photo Album - Photos for the Tip "Adding Altimeter Payload for Low Power Rockets"

These pictures are intended to illustrate the Tip that describes my method of adding an Electronics/Altimeter Bay to low-powered rockets.  This article is geared specifically for the Jolly Logic Altimeter One/Two, which is small enough to fit into a BT-20 body tube and light enough to be hoisted by a 1/2A motor or even T-motors (13mm).

Image 6 of 16
PreviousNext

Altimeter in padding. The small gap between PCB tab and plastic case needs "fresh air".


- Post a Comment -

EXIF Data

AttributeValue
TimeDecember 17, 2011 - 07:10:41
CameraOLYMPUS IMAGING CORP. u1010,S1010
F-Numberf/4.3
Exposure1/30 sec
ISO800
Exposure programNormal Program

- Link to this Page -