|Motor Size:||38 millimeters|
|Nose Cone Material:||Plastic|
This kit was my Junior. Level 1 and I must say it is a beautiful kit. Some people say this rocket is not good for certifications due to the fact that the fins hang below the body. But, unless you land on concrete or desert, these fins are hard to break off. This kit is four-feet tall, four-inches in diameter and, coincidentally, my finished weight was four pounds. I tend to build heavy and ...
Brief: This is a large single staged, simple mid/high power rocket. It uses parachute recovery and was my first big rocket. Mine came with a 38mm motor mount, although many websites say it has a 29mm motor mount. Also, the fin tabs extend all the way to the motor tube. Construction: The components of this kit came in the typical LOC plastic bag. All of the parts were of the highest ...
( Contributed - by Frank Ross - 11/11/00) Brief: Up-scaled to 38mm. Modifications: For my level-1 certification and my first high-power rocket I wanted a large, simple rocket kit without any bells and whistles. I chose the LOC-IV as I thought it looked to fit the bill, and wouldn't break my credit card. I decided to up-scale to 38mm rather than stick to 29mm because I liked the ...
Brief: An easy to build 3FNC rocket, built for my first shot with a reloadable motor. Construction: The kit contains a 4" kraft paper body tube, two centering rings (plywood) included, nose cone, 36" chute, elastic shock cord, 3 plywood fins, 29mm motor mount, and a 1/4" Launch Lug. This was a really easy kit to build. I spoke to LOC briefly regarding the fins, ...
- by Tom Bell Instructions: The instructions were complete and easy to follow. Although this is a large rocket, it was not difficult to build. The parts were well manufactured and fit together without problems. This kit was my first large rocket, and it is a good starter kit for large rocketry despite its imposing size. This kit requires epoxy for assembly of the ...