|
|
Mark S's PageRocketReviews.com Pages:
2022-11-12Silver Hawk II Flight Boost was low but straight. Streamer failed to eject and rocket hit the ground in one piece. Body tube is crunched, glider broke along two joints but easily repaired. - A10-3T - Rio Rancho [More]
Alien Green Flight Great flight. Slow liftoff, stayed in sight, ejection just after apogee, recovered near the pad. - C6-5 - Rio Rancho [More]
mega mosquito Flight Great flight. Slow liftoff, stayed in sight, ejection just after apogee, recovered near the pad. - E12-4 - Rio Rancho [More]
2022-04-09Alpha Cam Flight Rocket blew off fin unit at ejection due to poor glue joint. Remainder of rocket found later by another club member, video did not save due to rough landing. - b6-4 - Rio Rancho [More]
Nighthawk II Flight Rocket launched while I wasn't looking. Boost fairly straight, glider had stalling issues for 25-30 sec flight. - B4-2 - Rio Rancho [More]
2019-12-14Leviathan Flight Delay charge never burned and rocket augered straight into the ground. Forward section is a total loss. - G76-7 - Rio Rancho [More]
Ascender Flight Beautiful launch. Recovery went well except that nose cone separated from the payload bay, but the nose cone was recovered nearby. - F15-8 - Rio Rancho [More]
mega mosquito Flight Very fast liftoff and beautiful recovery. Aft section of the rocket landed on its fins. - E28-4T - Rio Rancho [More]
2019-08-10Jetliner Flight Poor flight, not enough altitude to eject. Both engine nacelles cracked. - A10-3T - Rio Rancho [More]
Ascender Flight "thrilling" wait until ejection, but the long delay reduced drift on recovery. - F15-8 - Rio Rancho [More]
| Mark S More:
RSS Feeds: |
- Link to this Page -
You can link to this page using the following HTML or BB Code.
Text Link in HTML (for web sites)
<a href="https://www.rocketreviews.com/mark-ss-page.html">Mark S's Page</a>
Text Link in BB Code (for forum posts)
[url=https://www.rocketreviews.com/mark-ss-page.html]Mark S's Page[/url]
Select the appropriate text with your mouse then "right-click" and select "Copy." Then, paste the text into your web site's code or a discussion forum post.
|
|
|
|