I was reading through TRF archive and came across a thread by Bob Sanford. Bob worked for and developed the Initiator design for Enertek and later Aerotech. He took a trip to Phoenix and Centuri in ... [Read More]
I almost didn't go to the Tampa TTRA launch today. I had a evening show scheduled and realized the venue was only ten miles from the TTRA site! So, it was a launch in the afternoon then banjos at ... [Read More]
I drove to Oviedo, FL (JonRocket.com Headquarters) to pick up Roger Smith. He had a new camera and put it to good use today! Still pictures are mine, all action shots were taken by Roger. Roger's ... [Read More]
The Canadian Rocket Store has scanned many kit instructions including the new Rocketarium models. Simply go to: http://www.allrocketengines.ca/ And find a model you are curious about. Go to the ... [Read More]
I went to the Quest website HERE to check the availability of the Q2G2 igniters. I read on a forum that they were on back order. The opening page had specials: A Big Dog kit with a "Free" ... [Read More]
I got my Quest X-15 parts packs yesterday. The body tube and centering rings were not in the parts pack, you'll need those Quest parts to make the model. An ST-7 engine mount tube fits the Quest ... [Read More]
75Granville posted on TRF about the out of stock Quest Q2G2 igniters: "Was poking around the Apogee website today, and in the Upcoming Products section(s) they show Quest motors. (Bottom of ... [Read More]
After much speculation about igniters and supplies, Bill Stine posted this on TRF: OK, here's an official response from Quest: First, NO, Q2G2 igniters are NOT gone forever and you will be ... [Read More]
I know, I've gone over to the dark side. Not really, I had launched a few Enerjet E engines in the late 1970s. I ordered this 24/40 reloadable engine casing for use in some heavier models that ... [Read More]
December1 on YORF, CTRRockets posted the question: "I was in my local hobby shop looking for a kit and some engines and I asked for Quest engines. They told me they have been having issues with ... [Read More]
Is Quest ill? That question was posted by Blackshire on YORF. If you visit the Quest website ( CLICK HERE) and click on most engine listings you get this message: "This item is currently Out ... [Read More]
Bob Jablonski (Starlight Model Rockets and Countyline Hobbies) posted these on Facebook - thrust curves for upcoming Quest composite 18mm engines. The upper picture is the thrust curve from a C14-5 ... [Read More]
Every major vendor has their own version of a "school rocket". All claim theirs is easy to build. This new NEXUS model from Discount Rocketry - ModelRockets.us might have the winning design edge. ... [Read More]
On the NAR Facebook page - John Wilkerson posted some pictures from the NARCON Manufacturers Presentation. I'm sure there were other products, these seemed the most interesting. Matt Steele ... [Read More]
On TRF, Winston posted a link to the 2020 NARCON Maunfacturer's Forum. The video was produced by Apogee. CLICK HERE At 0:01 - AEROTECH - Available in the Fall, Q-Jets will ... [Read More]
I was reading through TRF archive and came across a thread by Bob Sanford. Bob worked for and developed the Initiator design for Enertek and later Aerotech. He took a trip to Phoenix and Centuri in ... [Read More]
